Description
Bitumen Corrugated Roofing Sheet Clear 2000 x 950 mm
Roofing Sheets
Clear – 950mm wide by 2000mm
These sheets are compatible with the bitumen roofing sheets. Useful for roofs that need a little extra light transmission. They are a direct replacement for a single sheet of bitumen roofing.
They can be used for the following:
- Car port roof/siding
- Garden building roof – pegolas/pergodas
- Shed replacement roof – massively outlasts felt offerings
- Garage roof – replace your damaged metal roof or old asbestos roof
- Farm buildings – roof and wall coverings
- Log stores
- Children’s play houses
They can be used horizontally on a roof and can also be used vertically. The fixing method remains the same.
Full fitting instructions can be supplied if needed. Failure to comply with these fitting instructions in anyway will invalidate any returns or replacement sheets, fixings or finishing trims.
More than 15 degree Pitch
For a roof with a pitch (angle) of more than 15 degrees, each sheet should be supported across its width by appropriate sized timber no less than 50cm (500mm) apart, measured centre to centre. If the sheets are to be overlapped on their length, they should be overlapped by no less than 18cm (180mm). Overlapping these sheets width ways by one corrugation is accepted at this pitch, making the width coverage 835mm.
Between 10 and 15 degree Pitch
For a roof with a pitch (angle) of between 10 and 15 degrees, each sheet should be supported across its width by appropriate sized timber no less than 40cm (400mm) apart, measured centre to centre. If the sheets are to be overlapped on their length, they should be overlapped by no less than 22cm (220mm). Overlapping these sheets width ways by one corrugation is accepted at this pitch, making the width coverage 835mm.
Between 5 and 10 degree Pitch
For a roof with a pitch (angle) of between 5 and 10 degrees, each sheet should be fully supported by appropriate sized sheet timber ‘deck’. If the sheets are to be overlapped on their length, they should be overlapped by no less than 32cm (320mm). Overlapping these sheets width ways by two corrugations is needed at this pitch, making the width coverage 740mm.
Less than 5 degree Pitch
These sheets are not suitable for a pitch of less than 5 degrees.
